24
Instructions for Use V1.2, RevE – 08/2016
• Cut the hose roughly in the middle between the Y-connector and the
rinsing station.
• Use the extension connector (
20
) included with the package to attach an
additional hose section (
21
) of the required length.
• To do this, measure the length of the hose again, and if necessary cut it
to exactly the required length.
• Push both ends of the hose as far as they will go onto the extension con
-
nector, and then secure each hose with a cable tie (
18
).
• Finally, check again that the rinsing water container is positioned hori
-
zontally on the platform.
4.6 Remedy if hose is too short
If the hose (
21
) at one of the stations should be too short, or if a hose has
been cut too short by mistake, the following remedy may help:
18
20
21
Fig. 29
4.
Instrument Setup
