Leica DMIL, Инструкция по эксплуатации

Страница: 25 / 244

25
• Check the voltage setting on the rear panel of
the unit. Depending on the country of use, this
setting can be 100 V, 115 V or 230 V. The vol-
tage setting can be corrected as follows:
• Use a screwdriver to press on the latch
(25.2) and remove the fuse holder (25.1).
• Pull out the voltage selector module (25.3).
• Insert the voltage selector module into the
holder so that the number which corre-
sponds to the desired mains voltage (25.4)
appears on the outside (upside down).
• Insert the fuse holder (2.1) until the latch
clicks audibly in place.
• If you purchased additional options with the
microscope, install these options first (see
next chapter).
Attention!
For external lamp power units, always per-
form the mains voltage setting as described
in the manual which is supplied separately, or
use a power transformer.
• Then connect the microscope with the power
cord (2.4) and connect it to the mains supply.
Attention!
Observe the safety information on pages 7
and 8!