4
LIVE CONTROL AND FEEDBACK
The
Object Editor
for QIS shades contains a panel with controls that allows live control and feedback of the selected shade. This
panel appears when there is a live connection to the controller, and the controller has been programmed. The panel contains controls
for shade identification using the
Jog Shade
,
Open
,
Close
, and
Stop
buttons. Also, a graphical representation of the shade at its
current position, is displayed. The graphical shade will also act as a slider to set the position of the shade – click and hold the bottom
edge of the shade to move up or down as wanted, then release.
NOTE:
The slider operation will not position the shade correctly until the lower limit has been set.
Note:
QIS Live Control Editor with close, stop, open, and etc.
control buttons only appears when the system is programmed
and Design Center has a live connection to the controller.
Live Control Editor with close, stop, and open buttons, and the
Configuration (limits) tool selected.
INFUSION CONTROLLER TO PCP RJ-45 CONNECTION - DETAILED
Wiring from IC-36-II, IC-DIN-II, or IC-DIN-II-LITE to RJ-45 connections on PCPs
WIRING DIAGRAM
T/R
+
T/R
_
T/R
_
T/R
+
BUS 1
BUS 2
T/R
+
T/R
_
GN
D
T/R
+
T/R
_
GN
D
ON
OFF
CONTROLLER
NETWORK TERMINATION
CONTROLLER BUS
ETHERNET
STATION BUS
RS-485 PORT 1 RS-485 PORT 2
SERIAL NUMBER
IC-DIN-II
T/R
+
T/R
_
GN
D
STATION
BUS
RS-485 PORT 2
SERIAL NUMBER
IC-DIN-II-LITE
ETHERNET
Secondary Enclosures
Bus 2
Bus 3
Bus 4
T/R+
T/R
–
Gn
d
T/R+
T/R
–
Gn
d
T/R+
T/R–-
Gn
d
Override
RS485-1
RS485-2
1
2
3
4
5
6
7
8
MAIN ENCLOSURE TERMINAL BOARD
RS-485 CONNECTIONS
RJ-45 / CAT5e-CAT6
FROM CONTROLLERS
TO PCP
NOTE:
Ground may use
wires 6, 7, or 8
1
2
3
4
5
6
7
8
