Installation Instructions
LPE1U
13
9.
If the display has a recessed mounting surface, protrusions
or a power box, a spacer and longer mounting hardware
must be placed between the display and vertical mounting
bracket (WR). (See Figure 17)
10. Repeat Steps 5 through 8 for Right side vertical mounting
bracket using the same hole locations to align brackets
horizontally.
11. Determine and mark the horizontal center position between
the Left and Right
TOP
mounting holes in display.
(See Figure 18)
12. Determine and mark the horizontal center position between
the Left and Right
BOTTOM
mounting holes in display. (See
Figure 18)
13. Orient upper horizontal mounting bracket (WQ) so that
flanges are facing towards display and resting in recessed
area of left and right vertical mounting brackets (WR). (See
Figure 18)
14. Adjust Upper horizontal mounting bracket (WQ) position
until center diamond in horizontal mounting bracket (WQ)
aligns with mark made in Step 11, and mounting holes and
slots in horizontal mounting bracket (WQ) are aligned with
threaded holes in mounting tabs of left and right vertical
mounting brackets (WR). (See Figure 18) and (See Figure
19)
15. Use 1/8" hex key (WP) to secure upper horizontal mounting
bracket (WQ) to left and right vertical mounting brackets
(WR) using four button head flanged screws (WN). (See
Figure 19)
16. Repeat Steps 12 through 15 for lower horizontal mounting
bracket (WQ).
IMPORTANT ! :
The orientation of, and mounting holes used,
when installing the lower horizontal mounting bracket must be
the same as the upper horizontal mounting bracket. Vertically
align upper and lower brackets by aligning holes or end of slots.
(See Figure 19)
IMPORTANT ! :
Whenever possible install mounting
screws diagonally as shown in detail in Figure 19.
17. Install display by inserting mounting buttons on horizontal
mounting brackets (WQ) into teardrop mounting holes on
faceplate making sure latching flags are in "open" position.
Figure 18
12
11
(WR) x 2
Center Mark
(WQ) x 2
Figure 19
15
15
(WQ) x 2
(WR) x 2
(WN) x 8
(WR) x 2
14
