LPE1U
Installation Instructions
8
Assembly And Installation
IMPORTANT ! :
The LPE1U packaging was designed to
help make the installation and setup easier. Do NOT
remove assembly prior to reading installation
instructions!
Cart Assembly
1.
Remove all boxes and smaller parts. Leave foam packaging
and other cardboard pieces inside to provide stability while
performing Steps 2-4. (See Figure 1)
2.
Lift column assembly (T) up by lifting at the bottom of the
assembly. (See Figure 1)
3.
Carefully set column assembly (T) base on the edge of box.
(See Figure 1)
Figure 1
4.
Use four 5/16-18 x 2 1/4" button head cap screws (L), 5/16"
washers (M) and four 5/16-18" hex nuts (J) to secure cross
brace (X) to column assembly (T) and bottom back cover
(B1). (See Figure 2)
NOTE:
Make sure cross brace is positioned in the proper
orientation before attaching. There is a "this side up"
label on the top. (See Figure 2)
Figure 2
5.
Place right transition cover (A2) on right cart leg (D), lining
up the holes on the cover with the holes on the leg and cross
brace (X). (See Figure 3)
6.
Place left transition cover (A1) on left cart leg (C), lining up
the holes on the cover with the holes on the leg and cross
brace (X). (See Figure 3)
CAUTION:
Attachment holes may be damaged if a power
drill is used to insert button head cap screws. Screws should
first be inserted and turned BY HAND with the hex key or with
a hand-held screwdriver BEFORE using the hex head drill bit
and power drill to complete the attachment.
7.
Use four 5/16-18 x 3 3/4” button head cap screws (N) to
secure legs (C and D) and covers (A1 and A2) to cross
brace (X). (See Figure 3)
Figure 3
8.
Remove cart from box by tipping it from the top onto its
wheels. (See Figure 4)
9.
Lock wheels to hold cart in position during installation.
Figure 4
1
1
remove parts and packaging
2
2
3
3
(T)
(L) x 4
4
(X)
(T)
(J) x 4
4
(M) x 4
(B1)
(X)
(C)
(A2)
5
7
(N) x 4
(D)
(A1)
5
6
6
8
