Installation Instructions
LFE1U
3
WARNING
:
RISK OF SERIOUS INJURY OR
DEATH! Relocating audio and/or video equipment to furniture
not specifically designed to support audio and/or video
equipment may result in death or serious injury due to the
furnishing collapsing or overturning onto a child.
NOTE:
The LFE1U stand has no user serviceable parts.
NOTE:
The LFE1U stand can support screen sizes up to a
maximum of 86".
NOTE:
The LFE1U stand is intended for Institutional Use.
NOTE:
To reduce the risk of electric shock, this furnishing has
a polarized plug (one blade is wider than the other).
This plug will fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician to install
the proper outlet. Do not change the plug in any way.
NOTE:
This product is a double-insulated, cord-connected
product and must be serviced accordingly. In a double-
insulated product, two systems of insulation are
provided instead of grounding. No grounding means for
grounding to be added to the product Servicing a
double-insulated product requires extreme care and
knowledge of the system, and is to be done only by
qualified service personnel. Replacement parts for a
double-insulated product must be identical to the parts
they replace. A double-insulated product is marked
with the symbol (square within a square)
NOTE:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to
radio communications. However, there is no guarantee
that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can
be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment
and receiver.
•
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV
technician for help.
IMPORTANT ! :
The LFE1U is designed to be mounted
to:
•
a bare concrete wall with a minimum thickness of
8" (203mm):
•
a bare 8" x 8" x 16" (203mm x 203mm x 406mm)
concrete block wall; or
•
a wood stud wall with a maximum drywall
covering of 5/8”.
•
a 2" x 4"-25ga minimum steel stud wall.
IMPORTANT ! :
Mounting with hardware to the finished
floor is optional, however the LFE1U CANNOT be
mounted exclusively to the floor without also being
attached to the wall!
IMPORTANT ! :
The LFE1U must be sitting on the floor
after it is mounted to the wall. It CANNOT be elevated off
the floor!
CAUTION:
Changes or modifications to this
unit not expressly approved by the manufacturer can void the
units FCC compliance rating and make the unit illegal to
operate.
Responsible Party:
Legrand | AV
6436 City West Parkway
Eden Prairie, MN 55344
866-977-3901
[email protected]
CAN ICES-3 (B)/NMB-3(B)
--SAVE THESE INSTRUCTIONS--
Electrical Specifications
Input voltage, frequency
100-240 V~, 50-60 Hz, 450W
Duty Cycle
Intermittent: 10%; max 2
minutes on/18 minutes off
Содержание Chief LFE1U
Страница 19: ...Installation Instructions LFE1U 19 ...
