4/4
IMPORTANT INSTRUCTIONS
IMPORTANT !
Wrong!
4"
(100mm)
On widest one flat plane (only)
Do not bend sideways.
Flexible on one axis
maximum band radius 4”
TROUBLESHOOTING
Tape light strip does not light
Ÿ
Make sure your power supply is turned on and has the correct voltage.
Ÿ
Conrm you have the correct polarity (+ to + and - and -) throughout the run of LED Lighting.
Ÿ
Have a electrician check all connections from the power supply to the LED Light Strips.
Ÿ
Consider testing with a multimeter to ensure light strip is receiving 24VDC power.
LED Flex Strip lights blink on, then go off
Ÿ
The power supply is not adequate for the length of LED Light Strips you are powering. Install a adequate listed Class 2 power supply.
LEDs farthest from the power supply are noticeably dimmer
Ÿ
This is the result of voltage drop. Decrease the length of the 24V power feed or use thicker power feed
wires between the 24V power supply and the
lighting strips
.
MAXIMUM FLEXSTRIP LENGTH SUPPORTED BY OUR CLASS 2 POWER SUPPLY
Power Supply
Max Feet of LED Flexstrips
Power Supply
Max Feet of LED Flexstrips
LV100-24N-UNV-J
18.18 Feet (Continuous 80 Watts)
XLD200B-224V-FC
2 X 18 Feet (Each Channel)
Total 36 Feet
LED GROW STRIP
™
Model:
FLS103T50FC060G-24
Apply 1 ½” long electrical heat shrink over all connection points. Secure connection wire with wire clamp.
Note: If using Type B, with GEL cover, peal back 3/8" (10mm) to access the electrical contact points.
1-800-387-4081
ledworldlighting.com ledworld.ca
Copyright © 2016 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).
LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 2.3 - 02/08/16
