Lectrosonics DM812, Справочное руководство

Страница: 16 / 51

DM Series Digital Matrix Processors
LECTROSONICS, INC.
16
Mute
Select MUT to view/change the mute state of the se-
lected crosspoint. Rotate the encoder knob to toggle
between choices Mute and Unmute.
Outputs Setup Screen
The Outputs Setup Screen controls the rear panel
outputs. The settings are accomplished in “real time,”
i.e., you will immediately hear the result of any changes.
When finished, use the front panel BACK button to
exit the Outputs Setup Screen and return to the Setup
Menus.
Parameter
Display Area
Items List Screen Title
Output
Channel
⇓
⇓
To open the Outputs Setup Screen, navigate to the
Setup Menu, highlight Inputs and press the PRESS
FOR MENU/SELECT control.
There are four sections to the Input Setup Screen:
Screen Title, Items List, Parameter Display Area and
Channel. The various entries in the Items List are
accessed via the Item Select Buttons below the LCD.
The Channel is the currently selected channel and the
Parameter Display Area displays the name and current
setting of the various parameters that can be adjusted
through this screen.
Output Select
The Output Select setting is used to view or change the
current output channel. It is accessed by pressing the
appropriate Item Select Button below the LCD. Rotate
the PUSH FOR MENU/SELECT control until the ap-
propriate output channel is displayed in the upper right
corner of the LCD. Press the PUSH FOR MENU/SE-
LECT control to accept the selection.
NOTE: Select the desired output channel with the
item select buttons before making the following
adjustments.
RP Gain
RPG is used to view or change the rear panel gain
setting for the selected output channel. This setting
is normally controlled by hardware connected to the
programmable input ports on the rear panel of the unit,
i.e., variable resistors (pots), switches, etc. (Refer to
the Online Help supplied with the software for more
information on rear panel gain.)
NOTE: RP Gain is an attenuator only, with a range
from 0 dB to -61 dB.
RPG is accessed by pressing the appropriate Item
Select Button below the LCD. Rotate the PUSH FOR
MENU/SELECT control to set the level of attenuation,
then press the PUSH FOR MENU/SELECT control to
accept the selection.
Source
SOU is used to view or change the signal source setting
for the selected output channel. The signal sources
can be the matrix, the 1 kHz Tone generator, the pink
noise generator, or the DANI if the unit is a slave in a
stacked configuration.
SOU is accessed by pressing the appropriate Item
Select Button below the LCD. Rotate the PUSH FOR
MENU/SELECT control to set the output source, then
press the PUSH FOR MENU/SELECT control to accept
the selection.
Level
M/L is used to view or change the output channel level
setting: Mic (microphone) or Line level. The Mic setting
applies 40 dB attenuation to reduce signal level. Only
certain channels support the Mic setting, which is a
hardware feature and the number of Mic level channels
available varies with the unit.
DM1624F 8 Mic/Line Switchable Outputs
DM1612F 4 Mic/Line Switchable Outputs
DM812 4 Mic/Line Switchable Outputs