Super-Minature Belt Pack Transmitters
Rio Rancho, NM
19
SYMPTOM
POSSIBLE CAUSE
HISS AND NOISE -- AUDIBLE DROPOUTS
1) Transmitter gain (audio level) far too low.
2) Receiver antenna missing or obstructed.
3) Transmitter antenna broken or missing.
/PERATINGRANGETOOGREAT
3IGNALINTERFERENCE4URNOFFTRANSMITTER)FRECEIVERSSIGNAL
strength indicator does not drop to nearly zero, this indicates
an interfering signal may be the problem.
Try a different operating frequency.
“Loc” APPEARS IN DISPLAY WHEN ANY BUTTON IS PRESSED
1) Control Panel is locked. (See
Operating Instructions, Locking
and Unlocking the Control Panel.
)
“Hold” APPEARS IN DISPLAY WHEN ARROW BUTTONS ARE PRESSED
2EMINDERTHATITISNECESSARYTOHOLDDOWNTHE!5$)/OR
&2%1BUTTONTOMAKEADJUSTMENTSTOTHEAUDIOGAINOR
frequency
settings.
“PLL” APPEARS IN DISPLAY
1) Indication that the PLL is not locked. This is a serious condition
that requires factory repair. It may be possible to operate on
another frequency far removed from the one that was selected
when the condition was indicated.
TRANSMITTER WON’T RESPOND TO REMOTE CONTROL
1) If LCD blinks “rc oFF”, transmitter has not been configured
to respond to the remote control. See “Remote Control
/PERATIONvONPAGEFORINSTRUCTIONSONHOWTOCONlGURE
)F,#$BLINKShvTRANSMITTERISALREADYSETAS
requested by the remote control.
3) If transmitter does not respond at all, try moving the remote
control closer to the microphone or increasing the remote
CONTROLSLOUDNESSSETTINGORINCREASINGTHEAUDIOLEVELONTHE
transmitter.
4) Make sure volume of RM and proximity of microphone are
sufficient to engage transmitter.
5) Make sure transmitter is not in Sleep mode.
RM Troubleshooting
FREQUENCY CHANGES, BUT NOT TO DESIRED FREQUENCY
1) RM set on different block than transmitter in question. RM uses
HEXCODETOSETFREQUENCYSET2-TOPROPERFREQUENCYBLOCK
or use hex code method to change frequency.
