3
7. Reinstall all three fuses in proper sequence, per
Fig. #10 and specifications table.
Salt Feed Tank:
1. Thoroughly rinse and wipe out tank.
2. Check to make sure the small vent hole in tank
cap is not blocked.
3. Rinse out connection hose with fresh water.
4. Clean T/Check Valve assembly.
STORAGE
Short Term Storage
NOTE: Failure to perform the following may
result in an odor problem and contribute to min-
eral buildup in the system.
If the boat's toilets are not going to be used for up to
one week, activate the treatment unit and flush the
toilet(s) twice for the complete flush cycle before
leaving the boat.
Long Term Storage
If the boat's toilets are not going to be used for over
a week, follow short term storage instructions and
also purge the toilet hoses and Lectra/San EC with
fresh water.
See Recommissioning and Start up.
WINTERIZATION
WARNING: DO NOT USE ANTIFREEZE IN
LECTRA/SAN EC.
1. Run Treatment Cycle five times, flushing the
toilet for the entire duration of the 40 second
flush cycle.
2. Close seacocks.
3. Disconnect and drain hoses.
4. Using a pump, remove water from the Treatment
Unit (through crossover cap).
5. The electrode pack should be inspected and
cleaned. Remove the Treatment Unit Cover and
pull out the electrode pack. Rinse with fresh
water and clean with a stiff non-wire brush.
Empty any remaining water from the tank.
RECOMMISSIONING & START UP
1. Reconnect hoses and open seacocks.
2. Remove the three fuses from the Control Module
(located on the top of the Treatment Tank). Mark
Fig. #4 - Lectra/San EC with vented loop (below waterline)
Below Waterline Installation Requires Vented Loop Between
Lectra/San Treatment Unit and Thru-Hull Fitting
Fig. #3 - Lectra/San EC with holding tank (above waterline)
Lectra/San EC
Lectra/San EC
Raw Water Strainer
TWK
Intake
Thru-Hull
and Seacock
Intake
Thru-Hull
and Seacock
Discharge
Thru-Hull
and Seacock
Discharge
Thru-Hull
and Seacock
Y Valve
PHII Marine
Toilet
PHII Marine Toilet
TWK
Raw Water
Strainer
Vented
Loop
Vented
Loop
Deck Pumpout
Vented
Loop
Vent Outside
Hull or Deck
Vent Outside
Hull or Deck
Fig. #2 - Lectra/San EC with Vented loop (above waterline)
each fuse for replacement purposes. This will
allow operation of an electric toilet without acti-
vating the Lectra/San EC.
3. Flush the toilet four times, allowing approxi-
mately two gallons of salt water to enter the
Treatment Tank.
4. Reinstall the three fuses in proper sequence,
per Fig. #10.
INSTALLATION
Use Figures #2 through #4 which show some instal-
lation options. (Drawing are not to scale.)
WARNING: Below waterline installations must
include a vented loop. The top of the loop must be
