www.lec-commercial.co.uk
5
Positioning your Lec Commercial bottle cooler
When positioning your Lec Commercial Bottle cooler, please ensure you have taken
into account the following factors:
In order to conserve electricity, do not put your appliance near a source of heat,
such as a radiator. Try to avoid locations where the appliance could be exposed
to direct sunlight.
An unheated location such as a cellar is undesirable as it may cause frost build up
and slow defrosting. It may also cause excessive condensation on the outer
surface of your cabinet.
The cabinet should be placed on a hard flat surface for ventilation. The feet must
be adjusted so that the cabinet stands firm and level with a slight tilt from front
to back, to prevent any defrost water dripping from the front.
Ensure that the appliance has sufficient clearance around it to provide adequate
ventilation – 10cm at each side, 6cm at the rear and 2.5cm at the top.
The internal temperature of this appliance is affected by location, room
temperature, and frequency of opening the door. The factory settings of the
electronic control (thermostat) are set to allow for these conditions. This
appliance is designed to operate in ambient temperatures b16°C and
+38°C. Operating outside of these temperature parameters may cause the
appliance to perform out of specification.
