LEAK
SAFE
SOLUTIONS
|
WATERSWITCH2 INSTALLATION INSTRUCTIONS
|
VERSION 3
PAGE 11
1 orange flash & 1 beep every 60 seconds
LOW BATTERIES, CHANGE BATTERIES ASAP
2 orange flashes & 2 beeps every 60 seconds
VALVE HAS BECOME DISCONNECTED FROM WATER
VALVE CONTROL (if this option was selected)
1 red flash & 1 beep every 20 seconds
VALVE CLOSED DUE TO MAINS POWER FAIL
(if this option was selected)
Green flashing every second & 2 beeps
VALVE CLOSING
2 red flashes & 2 beeps every 20 seconds
VALVE CLOSED DUE TO A WATER LEAK
BEING DETECTED
Fast green flashing every 0.5 second & 1 beep
VALVE OPENING
3 red flashes & 3 beeps every 20 seconds
VALVE CLOSED DUE TO WATER CONTINUOUS FLOW
TIMER BEING EXCEEDED
3 red flashes & no beeps every 20 seconds
VALVE CLOSED DUE TO NO FLOW TIMER BEING
EXCEEDED
Solid green
WATER VALVE CONTROL OPERATING ON MAINS
POWER
Support and FAQ’s are available to view or download at
www.leaksafe.com/support
To manually operate the valve, lift and turn the
operating button (Fig 10). When the valve is open the
red line in the valve status window is parallel to the
water pipe and at right angles when closed.
Push operating button down when finished.
Manual
operating
button
Valve status
window
Fig 10.
4. INDICATORS AND ALARMS
3.4 Manual override on the Motorised Valve
LEAK ALARM VALVE OPERATING
WARNING
3.3 Isolating a leak and turning the water on
Leaksafe recommend you repair all leaks before the mains water is turned back on.
Where a detected leak is from an appliance e.g., a washing machine, and the leak can be contained by not using that appliance, it is
possible to isolate that zone to allow the Leaksafe system to be reset and the water turned back on.
IF LEAK DETECTION IS DISABLED IN ANY PART OF A PROPERTY THAT AREA IS UNPROTECTED AND THE SYSTEM
WILL NOT ALARM OR SHUT THE WATER OFF IF ANOTHER LEAK OCCURS IN THAT AREA.
THE DECISION TO DISABLE ANY PART OF A LEAKSAFE SYSTEM LIES WITH THE OCCUPIER AND LEAKSAFE
ACCEPTS NO LIABILITY WHATSOEVER FOR THE CONSEQUENCES OF THAT DECISION.
To isolate a zone:
1. Unplug the leak detection tape protecting that zone from the Wireless Transmitter or Water Valve Control.
2. Press “WATER OFF” on the Water Valve Control.
3. Press “WATER ON” on the Water Valve Control to open the valve and restore water to the property.
IMPORTANT: When the leak is repaired, REMEMBER TO DRY AND RECONNECT THE LEAK DETECTION TAPES.
