LEAK
SAFE
SOLUTIONS
|
WATERSWITCH2 INSTALLATION INSTRUCTIONS
|
VERSION 3
PAGE 07
1.8 Resetting the Water Valve Control after a test alarm or when enrolling wireless components:
1. Press and hold down the WATER OFF button on the Water Valve Control until it beeps 3 times. The audible alarm
and LED flashing will stop but the Valve will remain closed.
2. Press and hold down the WATER ON button until it beeps once.
3. The Valve will open and the system is reset.
1.7 Deleting the Water Valve Control memory
This will clear ALL enrolled wireless devices – wireless leak detector transmitters and wireless On/Off switches and reset the Default
Settings and Continuous Flow or No Flow settings to factory default (see sections 1.2 & 1.3).
1. Press and hold down the TEST button for approx. 15 seconds until the Water Valve Control beeps and all the LED’s flash.
2. Release the TEST button.
3. The Water Valve Control memory has now been erased. You will need to re-enrol any wireless devices and reset the Default and
Flow settings – sections 1.2 & 1.3
1.6.4 Testing the Wireless On/Off Switch
1. Ensure the On/Off Switch is at least I metre away from the Water Valve Control, press the WATER OFF button on the Switch. The
Valve Control will beep twice, the VALVE OPERATING green LED will flash, and the valve will close.
2. Press WATER ON to reopen the valve.
1.6.3 Installing batteries and enrolling a Wireless On/Off Switch
1. Install the CR2032 battery.
2. Ensure that the On/Off Switch is at least 1M away from the Water Valve Control.
3. Press the TEST button on the Valve Control 4 times, holding the button down each time until the LEDs illuminate and the Valve
Control beeps. The first three times all 3 LEDs will illuminate, on the fourth time the orange WARNING LED will flash to indicate
the Valve Control is in ENROL mode.
Please note that occasionally the system will enter ENROL
mode after only 2 or 3 presses of the TEST button. As soon as
the WARNING LED starts to flash the system is in ENROL mode
and you can proceed to step 4. NB: The TEST button needs
to be held down for approx 4 seconds to operate. Release
the button when the Valve Control beeps.
4. Within 15 seconds of the WARNING LED starting to flash press
and release the WATER ON button on the On/Off Switch (fig 6)
– the Water Valve will beep and the orange WARNING LED will
stop flashing to confirm that the enrolment was successful.
Delay 1 HR
Water OFF
Water ON
Delay 2 HR
Delay 3 HR
Toggle
ON/OFF
Figure 6.
