LeGriddleUS.com | [email protected]
Your new Le Griddle arrives configured to operate on propane (LP) gas. To convert it to Natural Gas please
Please follow these simple steps.
1.
Remove the griddle plate by lifting straight up. Be careful, it is VERY heavy.
2.
Remove the screw located at the rear of each burner (Pic #1)
3.
Remove the nut located under the front control panel which also holds burner in place. (Pic 2)
4.
Carefully remove the 10 mm nut that holds the thermocouple in place (Pic 3) Note the position of the
thermocouple as it is important to replace it in the same position later.
5.
Lift up the rear of the burner just enough to pull it back and set it aside to gain access to the orifice
located
in the front control panel. Be cautious of the ignitor wire and ceramic tip which are still attached
and are
fragile.
6.
Using a 7 mm socket, gently remove the original orifice and replace it with the natural gas one. The natural
gas orifice
(hole)
is slightly larger than the LP due to the properties of the gas.
7.
Put the burner back in place, replace the thermocouple nut mounting it back where it was, then replace
the nut under the control panel and the screw in the rear of the body and you're done!
Pic 1
Pic 4
Pic 2
Pic 3
8.4.2020
Le Griddle LP to Natural Gas Conversion Steps
Remove Screw
Remove Nut
Remove Nut From Thermocouple Then
Pull the Thermocouple Out From The
Bracket. Note the Position of The Tip of
The Thermocouple Before Doing So.
Remove Orifice
