LeGriddleUS.com | [email protected]
Changing the gas bottle
LP Cylinder must always be changed with the control knobs in the off position and the
valve of the gas bottle shut.
LP Cylinder must be changed in a well-ventilated place, away from any heat sources
(cigarette, electrical appliance, etc.).
Always check for gas leaks after every LP Cylinder change.
Use
S
tarting up
1.
Once installed, the appliance is ready to use. Make sure the gas valve on the cylinder
is turned on. If you smell gas, shut the gas valve of the LP gas cylinder and tighten the
connections again.
2.
Turn on the valve by turning the knob to the left,
turn the control knob to big flame
position
(drawing on knob).
3.
Holding it in this position, push the knob in and press the ignition button until it
generates a spark and light
s
the burner
.
4.
Keep the knob depressed for 5 to 10 seconds to trigger the thermocouple safety system.
5.
Then release the knob and allow the burner to heat the hot plate to the right
temperature.
6.
Your appliance is now ready for
cooking on
.
7.
Please allow it to warm up approximately 10 minutes.
Surface temperatures and cooking times
will vary depending on the type of gas used, LP or natural, the ambient temperature while cooking
outdoors as well as other factors. To help you with this, we have tested the Le Griddle and found the
surface temperatures to average approximately 185 degrees after 10 minutes on high, 228 after 15
minutes, 280 after 30 minutes and 300 after an hour. We do not recommend cooking on high, we did
this to perform the test. Medium is the preferred temperature setting for most foods.
Comments
- The appliance may give off a little smoke or odor the first time it is used; this is normal.
- Each time
the Griddle
is
used
, push and turn the knob to the big flame position and
hold it
down for
two
seconds to allow air to escape, then
push ignition button and hold
for two more seconds, then
release the knob.
- To see the flame, look through the side of the appliance.
Shutting Down
1.
After use, switch off your appliance, turning the knobs clockwise to Off position.
2.
Shut the gas bottle valve.
3.
Disconnect the gas hose from the appliance and store in a dry, well ventilated place. The
gas
b
ottle must also be stored in a dry, well ventilated place, away from any heat sources.
Cooking:
Over time, you will be able to gauge the right cooking temperature according to the
thickness and texture of food and adapt it to your taste.
