Astro 250 Wi-Fi RGBW, DMX 512+ RDM LED followspot - User’s Manual – 1.0
Luci della Ribalta srl, Via Berna 14, 46042 Castel Goffredo (MN) Italy
Tel. +39 0376 771 777 – fax +39 0376 772 140 – email
– web www.ldr.it
6
8. VOLTAGE
Before operating this unit please refer to the product label mounted at the back of the luminaire to
check you are operating with the correct voltage.
The Astro 250 LED can be operated between 100V and 260 VAC.
9. LOCAL CONTROL PANEL AND OPERATION
OPERATION: LCD display for DMX address, system setup and status details.
POWER: power LED status indicator , red colour. ON= power
DMX: DMX LED status indicator, green colour. LED OFF = DMX OFF and manual control activated ,
LED ON = DMX MODE activated with no DMX signal, FLASHING LED = receiving DMX
MENU: rotary switch selector to select and modify the operational modes.
Turn left or right to navigate through the menu and press to select or to confirm
DMX IN: input DMX signal (pin1=0 , pin2= DATA- , pin3=DATA+ ).
DMX OUT : Loop through DMX signal output
POWER IN: Mains power input
POWER OUT: Mains power output
10. MENU
There are twenty-one different menus to control the settings of ASTRO RGBW LED. The rotary
selector is used to adjust the settings and to navigate through the menu. Turn left or right to select
the menu and push to access or to confirm the selected data or functions. To exit the selected
menus without saving the data, press the rotary selector for at least 1 second.
10.1 Wi-Fi, DMX OR MANUAL (Mode)
Colour control of the Astro is achieved through a totally innovative technology. The Astro Wi-Fi
generates a proprietary Wi-Fi access which will recognize one device only and whose range reaches
15m approximately in obstacle-.free environments. Access to the Wi-Fi access is protected by
password. A universal mobile phone holder (3.5/6.5in), rotatable over 360°, supplied with the Astro
and clamped on one of the side bars, allows the installation of a mobile device, either IOS or
Android to take control of the followspot.
If the Astro was purchased complete with the LDR controller A20702074 (available as an optional
accessory) Smartphone Honor 75 Black, pre-loaded with the Android Art-Net Controller app,
relevant settings and libraries, it is ready to be operated.
In case you are using your own mobile device, please refer to chapter 12 and 13 of this manual for
all the necessary steps needed to set up the control system.
Select the LED control mode between Wi-Fi (factory setting – if you want to control the colour
mixing through a mobile device), DMX and manual. To change the control mode press once the
rotary selector until an arrow appears on the menu. Turn the selector to the right or the left to
select the desired mode of operation and press to confirm your selection.
