LDA Audio Tech LDAVAP1, Руководство пользователя

Страница: 18 / 28

INDICATOR FAULT INDICATORS
ADDRESS EMIC FAULT LNK PWR EMIC
1 OFF OFF OFF OFF ON
2 OFF OFF OFF ON OFF
3 OFF OFF ON OFF OFF
4 OFF ON OFF OFF OFF
5 ON OFF OFF OFF ON
6 ON OFF OFF ON OFF
7 ON OFF ON OFF OFF
8 ON ON OFF OFF OFF
Table 4: ACSI Bus Address Signal
•
Push the recorded message "EVAC" and "ALERT" buttons to increase or decrease
the equipment address. With each tap the new address will be shown in the
indicators, as shown in the table 4.
•
Push the "ACK" button to confirm, "RST" to cancel the address change.
•
The computer will restart with the new bus address.
If when starting the VAP 1, "REMOTE CTRL" and "EMG" indicators light up simultaneously, there
is an address conflict with this device in the ACSI bus. In that case you must change the address.
4.4 VAP 1 CONFIGURATION
The VAP 1 allows to set different operating parameters. To access the configuration of the
equipment proceed as follows:
4.4.1 CONFIGURATION. WARNING TONE
To access the warning tone configuration, proceed as follows:
•
Make sure the computer is not in a condition of emergency. The "EMG" indicator will be off.
12
www.lda-audiotech.com/ en
Illustration 10: ACSI Bus Address Signal