2
1 Measure from hinge center line and mark drilling holes.
L
See mounting dimensions above as needed.
2 Drill holes where marked with a
Z\,
” drill bit.
L
SRT screws are used on metal doors.
Wood screws are used and recommended on wood doors.
Reduce installation torque if using SRT screws in wood.
3 Measure and determine your door’s width. Using a
B\cx
” hex
wrench, adjust the closer spring power. Use the table below to
determine number of turns required.
Turn counterclockwise for “-”; turn clockwise for “+”.
L
These turns are recommended, but may change due to
door weight and environmental conditions.
L
Do not use power drill to adjust spring force! It may cause
damage and void the warranty.
Door Width
Number of Turns
30" - 750 mm
-10
36" - 915 mm
0
48" - 1220 mm
+10
−
+
4 Install roller into track, then install end plugs.
For Hold Open
option, complete that
assembly, on page 4,
during this step.
5 Install track plugs onto track, install track onto frame.
L
See page 4 for Optional Hold Open Arm installation and
adjustment.
6 Install closer onto door using fasteners provided.
7 Install arm to closer.
a. Attach arm to the closer at a 45° pre-load position.
b. Secure with the provided pinion screw.
c. Attach the arm to the track.
45
°
8 Adjust the closer, if necessary. See page 4 for closer
adjustment instructions.
9 Install the shaft cover and closer cover.
Pull Side 180° Mount
Mounting Hole Dimensions
Right hand (RH) shown throughout instructions. Left hand (LH) opposite.
Frame
Door
21 C\v
"
6
"
12
"
Hinge
center line
4 Z\zn
"
1
"
1 C\zn
"
C\v
"
