28
Wyvern Timer 2000R Operating Instructions
Interrogation Menu
The interrogation menu is selected by pressing the UP programming button and allows you to
view the total on time and total money collected by the timer. In normal use both coin and card
data are accumulated together. If only coin data is required then card data may be ignored by
using program code 30 (page 26).
Time Used Interrogation
The following codes become available when the timer is set to the interrogation menu using
the UP button. Note: Although codes 03 to 05 have been used in the program menu the
following selection codes relate to the interrogation menu.
Total Time Accumulated Values
When you select one of these selection codes, the data values displayed ‘xx’ will indicate the
accumulated time ON recorded by the timer.
Selection
Codes
Description Maximum
Value
Value Used
03
Total time xx in hundreds of
minutes
-
04
Total time xx in minutes
-
05
Total time xx in seconds
-
Stored Total Time Programming Codes
To reset the total time and total money values to zero, the internal programming switch must be
set to the programming mode before pressing the UP button. All the code data values must then
be set to zero (selection codes 00 to 05 inclusive). The timer will only allow data values of ‘00’
to be entered (reset), if any other value is attempted the timer reverts to the original data setting.
Return the programming switch to normal for the reset to take effect. If any one data value is not
set to zero the original data values are retained for selection codes 00 to 05 inclusive.
Example
Suppose the following figures were obtained:
Selection code 03 gives a value of 05 (100 X 05=500 minutes)
Selection code 04 gives a value of 33 (1 X 33=33 minutes)
Selection code 05 gives a value of 25 (1 X 25=25 seconds)
So the total time recorded by the timer (500+33+25seconds) will be 533 minutes and
25 seconds.
