26
Wyvern Timer 2000R Operating Instructions
PC Programming (2000RPC only)
Using the PC interface allows direct programming and interrogation of the timer without using
the front panel hidden buttons. A PC interface module must be fitted to the timer to allow
connection to a PC’s RS232 serial port. The PC interface also allows use of customised
software to control the timer in specific applications. Instructions for the use of the Wyvern 2000
PC Interface are provided in the form of a PDF file on the CD containing the software.
Program
Code
Description Maximum
Value
Value Used
63
Select option 63, display shows
63co. Press PROG button, co
on the display starts to flash.
-
PC Interface Selection Code
Selecting Additional Features
Provision is made for additional features to be selected which affect other program codes.
These features would normally only be selected at installation. To select the feature it is
necessary to go to program code 30 and select the code shown in the table (for example if the
buzzer duration time is required to be in minutes instead of seconds enter code 01)
These codes are additive so to select buzzer in minutes
and
lockout in cool set program code to
03 or for proportional session cost and no card data set program code to 14 and so on.
NOTE.
The sum of the individual digits must not exceed 9 so for example program code 04 and
program code 08 cannot be selected to give program code 12 as this represents program code
02 and program code 10.
Program
Codes
Description Maximum
Value
Value Used
3000
No additional features selected
-
3001
Buzzer duration time in minutes
(code 20, Page 19)
-
3002
Lockout coins/cards during
‘Cool’ (code 25, Page 18)
-
3004
Proportional session
cost/session time (Page 2)
-
3008
Activate lockout after first valid
coin (Page 19)
-
3010
Card data not stored in
interrogation menu (Page 25)
-
3020
Door lock control
-
3040
Enable network devices
-
3080
Remote start & dual cycle
-
Additional Features Programming Codes
