Figure 8-2 the rotor installation
◼
Load the rotor on the spindle to ensure rotor is in position until it fit well with the spindle.
◼
Rotate the rotor slightly by your fingers to double check, if the rotor vibrates obviously, load
the rotor again.
◼
Hold on the rotor by one hand, tighten the nut clockwise by the other hand, and make sure
tighten firmly.
◼
Put the rotor lid on the rotor, press the fastener down and make the fastener join with the rotor
nut tightly.
◼
Close the door and start running.
◼
To release the rotor, first, pull the fastener up to remove the lid, and then, turn the rotor nut
counterclockwise.
CAUTION
：
Check that the rotor is firmly tightened before each start.
8.1.2
Set the operation parameters
Press the
button to select required parameters. The parameter can be modified when the
parameter is flashing. Clockwise rotate the parameter button
to increase parameter value;
counter-clockwise rotate the parameter button
to decrease parameter value. Parameter button
rotate faster, parameter value increase faster. The minimum speed increment is 100 rpm, the
minimum time increment is 1 second.
（
1
）
Set the speed
◼
Press the select button
, choose the speed unit rpm, showing the speed
parameter.
◼
While select speed button, the speed symbol will flash into the speed parameter
input status.
◼
The minimum speed value you can set 500rpm, the minimum increment is 100rpm.
Nut
Rotor Lid
Fastener
