REPLACING THE ELECTRONIC IGNITER
WARNING
Always make sure that the appliance is
COLD before attempting to replace the
electronic igniter. Handling hot parts can
result in severe burns to the hands and
fingers.
To replace the electronic igniter on models
LM210-20 and LM210-30, use the following
procedures:
REMOVAL
1. Remove Finger Grate Pan and Pan
Support from the appliance by simply lifting
up on the assembly and setting it aside.
2. You will now see the igniter mounted on
a holding bracket to the rear side of the
burner. Use a pair of needle-nose pliers
and carefully disconnect the lead wire from
the bottom of the igniter. Remove the
complete Igniter/Holding Bracket
Assembly from the burner support bracing
(Cross Brace) by using a right-angle Philips
screw driver. A straight Philips screw driver
can also be used by ‘angling’ the screw
driver into the head of the screw.
Igniter/Holding Bracket Assembly
REPLACEMENT
1. Place the new Igniter/ Holding Bracket
Assembly back into the original position.
Take special note that the igniter electrode
is positioned directly above one of the
burner ports. Secure using the original
Philips head screw.
2. Re-attach the lead wire to the bottom of
the igniter.
3. Test the igniter by depressing the Ignition
Switch and holding in. You should hear a
rapid ‘clicking’ sound.
4. Reinstall the Finger Grate Pan.
If you need further assistance, call the
LazyMan Customer Service team at:
(908) 475-5315 (800) 475-1950
They will be glad to help you!
Pan Support
Finger Grate Pan
Cast Iron
Burner
Igniter Location
19
