S1 Dream-T Espresso Machine
Owner’s Manual
Page 5
Understanding The Display
The display is the information center for the S1 Dream-T. It will tell you the time, boiler,
temperatures, water pressure, and will also give you an alarm message in the event of a
component failure. The diagram below shows the display in normal operation mode.
1. Current Active User Profile
2. Coffee Boiler Temperature
3. Time Of Day
4. Indicates If Water Supply Is Present
5. Water Pressure
(Shows line pressure when idle and pump
pressure when pump is engaged)
6. Steam Boiler Temperature
(Steam boiler must be on)
7. Indicates Steam Boiler Is Turned On
Power Modes
The S1 Dream-T can be set up to work in full power mode. In full power mode the machine
draws 20amps of power so a 20 amp receptacle and breaker must be used. If one is not
available then full power mode should be turned off.
In full power mode the machine is able to heat both boilers at the same time. This is helpful if
you want to be able to pull a shot and steam milk at the same time.
When full power mode is turned off then it is only able to heat one boiler at a time and will
always give priority to the coffee boiler. In this mode it is recommended to pull a shot and
steam milk separately or the machine may lose steam pressure if done at the same time.
Warning: Using the machine in full power mode in a 15 amp outlet should never be done.
Failure to follow this warning could pose a fire hazard and is not recommended.
