LawnMaster NPTBL26A, Руководство по обслуживанию

Страница: 4 / 40

4
SPECIFICATIONS
Ignition coil to cylinder
Apply the thermostable screw-thread glue into the
holes on cylinder and then pre-screw the 2 screws
(M5X20) securing the ground line, spacer and ignition
coil to cylinder. Insert a feeler gauge of 0.014 inch.
PPEHWZHHQWKHÀ\ZKHHODQGWKHLJQLWLRQFRLO
7LJKWHQWKHVFUHZVWR¿[WKHLJQLWLRQFRLO5HPRYHWKH
feeler gauge.
27-35 3-4
0XIÀHUWRFUDQNFDVH
Apply the thermostable screw-thread glue onto the 2
EROWV0;DQGVHFXUHWKHPXIÀHUWRWKHFUDQNFDVH
using the torque wrench.
71-80 8-9
Electric motor to motor
mount
Apply the thermostable screw-thread glue onto the
2 screws (M3X10) and secure electric motor to the
motor mount.
4-6 0.5-0.7
Carburetor holder to
cylinder
Apply the thermostable screw-thread glue onto the 4
screws (M5*20) and secure the carburetor holder to
the cylinder.
53-62 6-7
$LU¿OWHUEDVHDQG
carburetor to the
carburetor holder
Apply the thermostable screw-thread glue onto the
VFUHZV0;DQGVHFXUHWKHDLU¿OWHUEDVH
carburetor and washer to the carburetor holder with
the torque wrench.
27-35 3-4
Starter assembly to
engine mount Tighten the 3 self-taping screws (ST4.8*16) to secure
the starter assembly to the engine mount.
17-19 1.9-2.1
Engine to engine mount
Apply the thermostable screw-thread glue onto the
3 bolts (M5*20) and secure the engine to the engine
mount
48-51 5.4-5.8
Impeller
Secure the impeller to the crankcase. Place a washer
and a rubber gasket onto the impeller. Apply the
thermostable screw-thread glue onto the bolt (M8) and
then tighten.
106-115 12-13
Engine mount cover
Tighten the self-taping screws (ST4.8X16) to secure
engine mount cover. Then tighten the nonmetal nut to
secure bolt.
17-19 1.9-2.1
Fuel Tank
Attach the 2 anti-vibration washers onto the position
holes. Tighten the self-taping screw (ST4.8X20)
securing the fuel tank to the engine mount.
17-19 1.9-2.1
Engine Cover Assembly
7LJKWHQWKHVHOIWDSLQJVFUHZ67[)WRVHFXUH
the engine cover, engine mount cover and fuel tank.
Tighten the 5 self-taping screws (ST4.8X16) to secure
the engine cover assembly.
17-19 1.9-2.1
Main handle assembly
Tighten the 7 screws (3.9*16) to secure the right and
left parts of the main handle.
10-12 1.1-1.3