16
GUIDE BAR
Reverse the bar occasionally to prevent partial wear. The bar rail should always be a square. To
avoid one-sided wear, turn the guide bar over every time you replace the chain. You will also
have to move the guide bar tensioner to the other side of the guide bar.
To check for wear of the bar rail apply a ruler to the bar and the outside of a cutter. If a gap is
observed between them, the rail is normal. Otherwise, the bar rail is worn. A worn bar needs to
be replaced (Fig.15). Referring to figure 15:
1. Ruler
2. Gap
3. No gap
4. Chain tilts
GENERAL CLEANING
Always remove wood shavings and oil from the chainsaw after use. Clean the chainsaw by
brushing away dirt and waste residue that may be caught the machine. Wipe the chainsaw
clean with a damp cloth or hand brush. DO NOT use running water, solvents, strong
detergents or a high pressure washer to clean. (Use a mild detergent and sponge to clean
the plastic surfaces.)
Pay particular attention to the air intake area, keeping it free of debris.
Switch the chainsaw off immediately if the machine starts to shake or produce abnormal
noise.
TRANSPORTATION AND STORAGE
WARNING: Stop the motor and allow the chainsaw to cool before storing or transporting in a
vehicle.
Always carry the unit with the motor stopped, the guide bar covered away from your body.
Clean the chainsaw before storing.
Store the chainsaw indoors in a dry, ventilated and locked place, out of reach of children.
Store the chainsaw with all guards in place.
Attention:
Any maintenance and repair work beyond that described in this instruction
manual must only be performed by an authorised service agent.
TECHNICAL DATA
Model:
LSS 2035
Rated voltage:
230V
– 50 Hz
Rated output:
2000 W
Nominal Frequency
50 Hz
Chain oil type:
Chain oil Stock code:-90-30000
Chain oil tank capacity:
150 ml
Oil feeding system:
automatic pump
Chain type:
Lawn Star 80-27403 or Oregon 91P53X
Chain speed:
13.5 m/s
Guide bar type:
sprocket nose,
Guide bar length:
35 cm
Class of Protection:
II
Noise pressure level:
108 dB(A)
Noise power level:
88 dB(A)
Vibration rear handle:
3,597 m/s
Vibration front handle:
3,707 m/s