20
GB
MAINTENANCE
WARRANTY CONDITIONS
Before carrying out any maintenance work
•
on the high pressure cleaner discharge the
pressure and disconnect the electricity and
water supplies.
Cleaning the water filter: To ensure the pump
•
gives good service it is extremely important to
check and clean the water filter frequently. Use
pliers to extract it from the pump and rinse it
carefully in running water.
Cleaning the nozzle: A blockage in the noz-
•
zle may prevent the machine from operating
correctly, so it must be kept clean. Switch off
the machine and remove the lance. Clean the
nozzle with the pin provided. Rinse the lance
in running water.
Always keep the machine clean so that the
•
cooling air can pass through the slits without
obstructions.
To guarantee the appliance’s safety, use only
•
original spare parts supplied or approved by
the manufacturer.
If you are intending to store the machine in
•
places where there is a risk of frost, or to lea-
ve it unused for a period of more than 3 mon-
ths, a mixture of mliquid anti-freeze similar to
that used in cars should be sucked into the
machine before it is put into storage.
At start-up, small leaks may occur from the
•
pump; these will disappear after a few hours
in operation. Up to 10 drops a minute are ac-
ceptable; in case of larger leaks contact an
Authorised Service Centre.
The electric motor is protected against over-
•
loads. If the motor malfunctions, it stops. Wait
5-10 minutes before switching it back on. If the
problem persists, refer to the PROBLEMS AND
REMEDIES section. If you are still unable to eli-
minate the problem, stop using the appliance
When topping up the oil in the pump, use a
•
SAE 20W40 mineral oil. Quantity supplied:
70 gr.
Check periodically the gas oil filter (ref. 12,
•
pos. 1), and when it is damaged or too dirty,
replace it.
The replacement of the fuel metal pipe is
•
requested after number 2 disassembling to
avoid fuel leakages.
All our machines are subjected to strict tests and
are covered against manufacturing defects by a 24
month guarantee. If your high pressure washer or
accessories are handed in for repair, a copy of the
receipt must be enclosed.
Guarantee repairs are being made on the following
conditions:
That defects are attributable to flaws or defects
•
in materials or workmanship.
That the directions of this instruction manual
•
have been thoroughly observed.
That repair has not been carried out or attem-
•
pted by other than authorized service staff.
That only orignal accessories have been ap-
•
plied.
That the product has not been exposed to
•
abuse such as knocks, bumps or frost.
That only water without any impurities has
•
been used.
That the high pressure washer has not been used
•
for rental nor used commercially in any other
way.
The following are not included in the warranty:
parts subject to normal wear
•
the high-pressure tube
•
accidental damage, caused by transport, ne-
•
glect or inadequate treatment, incorrect or
improper use and installation failing to comply
with the indications in the instruction manual.
The warranty shall not cover any cleaning
•
operations to which the operative components
may be subjected.
Repairs under this guarantee include replacement
of defective parts, exclusive of packing and posta-
ge/carriage. The warranty shall not cover replace-
ment of the machine or extension of the guaran-
tee resulting from a breakdown. The manufacturer
declines all responsibility for damage to persons or
property caused by bad installation or mincorrect
use of the machine.
Fig. 12
1543Rev01 Man XTR 14l_multi.indd 20
30-11-2009 18:14:48
