![background image](http://html1.mh-extra.com/html/lavor/npx4/npx4_instructions-manual_3961693021.webp)
WATER SUPPLY
- Minimum delivery rate: 35 l/min.
- Water free from impurities.
- Maximum intake water temperature: 35
°
C.
Failure to comply with the above conditions
causes serious mechanical damage to the
pump and the loss of warranty cover.
HIGH PRESSURE HOSE
WARNING: The high pressure hose is
designed and produced to withstand high
pressures. To avoid damage, it must be
handled with special care.
Misuse may lead to premature breakages or
damage and cause the loss of warranty cover.
(See illustrations).
ELECTRICITY SUPPLY
-
The appliance's electrical connection must
comply with the IEC 364 standard.
Before connecting the appliance, make
sure that the nameplate data are the same
as those of the electrical mains and that
the socket is protected by a differential
security breaker with tripping sensitivity
below 0.03 A - 30 ms.
-
If the appliance's plug is not compatible
with the socket, have the socket replaced
w i t h a n o t h e r o f s u i t a b l e t y p e b y
professionally qualified staff.
Never use the appliance in ambient
temperatures below 0
°
C if it is equipped
with a PVC (H VV-F) cable.
-
If an extension lead is used, the plug and
socket must be watertight and the cable
must have the dimensions shown in the
table below.
230-240V
100-120V
2,5 mm
2
12 AWG
max 30 m
PLEASE NOTE:
This water cleaner is
equipped with the A.S.S. (Automatic Stop
System), which stops the machine during the
bypass phase. To start the water cleaner, it is
therefore necessary to set the switch to the
“ON” position; after that press the pistol trigger:
the Automatic Stop System will start the
machine and will stop it automatically when
the trigger is released. It is advisable to put on
the safety catch of the pistol trigger whenever
the machine is stopped, in order to avoid
unintentional starting.
• Any automatic start of the machine without
pressing the gun trigger is attributable to
air bubbles in the water or other similar
phenomena which do not imply the
existence of any defects in the machine.
• Do not leave the appliance unattended
during the standby mode for more than 5
minutes. Contrarily, for the safety of the
appliance it is necessary to re-turn the
switch into the OFF position.
• Please check that the coupling of the high
pressure hose with the appliance and the
gun supplied as standard equipment is
done correctly, that is to say without any
water leak.
If the appliance is equipped with a pressure
regulator:
• when the pressure is set to minimum the
A.S.S. may not trigger. Therefore, do not
allow the appliance to function in by-pass
for more than 1 minute.
• do not act on the gun lever too frequently
(this may cause a malfunction).
21
Содержание NPX4
