Superabrasive
Owner’s Manual Original Language – Lavina
®
V32-X-400-E
06/2019
13
5.6
INSTALLING LONGOPAC® REFILL PACKS
When the plastic bag cartridge has reached the end, the plastic bag refill may be installed using the following
procedures:
• Locate the 2 retaining levers located underneath the Longopac® bag support ring (Fig5.10).
• First pull down on the retaining levers, then rotate them 90 degrees so that the ends are pointing towards the center of
the machine (Fig 5.11) (Fig 5.12).
• Pull down on the bag support ring to remove, and place aside on a level surface.
• Place the Longopac® bag refill into the support ring. Ensure that the 2 ends of the refi ll are directed in an upwards
position. Pull the inner end of bag refill down over the inside surface of the bag support ring (Fig 5.13).
• Lift the bag support ring into place so that the bottom is located above the bottom edge of the hopper
container (Fig 14).
• Rotate the 2 retaining levers bacwards so that the ends are pointing outward and holding the bag support ring in place
(Fig 5.10).
• Pull the outer edge of the bag down over the support ring until a zip tie, or cable tie, can be installed all the way
around the bag.
• After the zip tie has been securely installed, pull the bag down until the end reaches the lower, bag-support plate. The
vacuum cleaner is now ready for operation (Fig 5.9).
6. MAINTENANCE AND INSPECTION
Figure 5.11
Figure 5.12
Figure 5.13
Figure 5.14
Figure 5.10
