10
OPERATION INSTRUCTIONS
WARNING
：
1. Close the valve of the gas cylinder or the regulator after use.
2. Do not move the heater, or cover it with protective cover after it has been turned off until the
temperature has cooled down.
Operation Checklist
For a safe and pleasurable heating experience, perform this check before each use.
Before Operating:
1. I am familiar with entire owner’s manual and understand all precautions noted.
2. All components are properly assembled, intact and operable.
3. No alterations have been made.
4. All gas connections are secure and do not leak.
5. Wind velocity is below 10 mph.
6. Unit will operate at reduced efficiency below 40°F.
7. Heater is outdoors (outside any enclosure).
8. There is adequate fresh air ventilation.
When heater is ON:
The flame should be blue with straight yellow tops. If excessive yellow flame is detected, turn off
heater and consult “Troubleshooting” on page 18.
B. DIRECT OPERATION ON THE CONTROL UNIT
TO TURN ON THE HEATER
1. Turn on the valve of the gas supply cylinder.
2. Press the POWER button for 2 seconds, release and press again to start ignition.
3. Press the POWER button to switch to the temperature heat setting.
Every time the POWER button is pressed it will switch from MAX-MED-LOW-OFF.
TO TURN OFF THE HEATER
1. Press the POWER button (until it switches to OFF).
2. Turn off the valve of the gas cylinder and disconnect the cylinder.
WARNING
FOR YOUR SAFETY
Be careful when attempting to manually ignite this
heater. Holding in the control knob for more than 20
seconds before igniting the gas will cause a ball of
flame upon ignition.
WARNING
FOR YOUR SAFETY
Heater will be hot after use. Handle with extreme care.
MAX
MED
LOW
OFF
ON
MAX -MED-LOW-OFF
Power indicator (ignition batteries)
AUTO SET indicator (for more advanced remote control only)
IR remote control receiver
AUTO PWR
