Launch VALUE-100, Руководство пользователя

Страница: 35 / 50

LAUNCH VALUE-100 A/C Service Station User’s Manual
1) Disconnect the machine from mains supply.
2) Wear gloves and safety goggles.
3) Remove the rear cover and right plate.
4) Close the taps of the on-board bottle, and close
High/Low pressure taps.
5) Close both valves of the internal bottle and the valve
[1,fig.12] of the filter [4,fig.12] .
6) Connect the L.P. quick coupler to the fitting [2,fig.12]
of the filter [4,fig.12]. Connect the L.P. quick coupler to Low
pressure tap with the blue hose. And open the L.P. quick
coupler.
7) Connect the machine to the power supply.
8) Open the Low pressure tap, make a recovery phase.
9) Once the reading of the pressure is ZERO, close
immediately the valve [3,fig.12] of the filter [5,fig.12] and press
Stop or Reset.
10) Disconnect the machine from the power supply.
11) Disconnect the L.P. quick coupler from the fitting
[2,fig.12] of the filter [4,fig.12].
12) Replace the old filters with the new ones, paying
attention at the direction of the arrows.
CAUTIN:
Replace the old filter with the new one as quickly as
possible in order to avoid possible contamination with the humidity in
the ambient air.
13) Open the valve [1,fig.12] under the filter [4,fig.12] and
the valve [3,fig.12] of the filter [5,fig.12]
14) Open both valves of the refrigerant bottle.
15) Mount the rear cover and right plate.
16) Connect the machine to the power supply, and turn on
the machine
17) During the first 10 seconds (when the service alarm
[SERV] is displayed),press the SEL key.
18) Type in the filter code to cancel the alarm (use the + and
ARROW keys).
19) Recover about 500g of gas to charge the machine
circuit.
20) Switch off the MACHINE
21) Disconnect the machine from mains supply.