LAUNCH
X-631 Wheel Aligner Product Service Manual Appendix 4
8-6
The same as above, please click button “Probe2” to test FR probe rod (2#), CCD1 is corresponding to 2#CCD at the end of
the probe rod, and CCD2 is corresponding to 4#CCD in the middle of the probe rod; click button “Probe3” to test RL probe
rod (3#), CCD1 is corresponding to 7#CCD at the end of the probe rod, and CCD2 is corresponding to 5#CCD in the middle
of the probe rod; click button “Probe4” to test RR probe rod (4#), CCD1 is corresponding to 8#CCD at the end of the probe
rod, and CCD2 is corresponding to 6#CCD in the middle of the probe rod.
C. Accuracy Checking
Run X-631 main program, System Management F5 –
〉
Maintenance for Probe Rod F9 -
〉
Accuracy Self-test for probe rod F4,
please perform the operation according to the prompts.
D. Operating Procedures for Replacing Main-board
