- 39 -
ALARMS
: it is displayed if, at batching start, the weight on the scale is higher than the minimum set
in constants (
). Press ESC
to return to the weight displaying, press ENTER
to cancel
the alarm and continue with the batching. If the weight comes back below to the minimum
set, the batching starts.
: it is displayed when at the batching start the APPROVAL input is open (if the input 3 is
set as approval; In 3 =
). Close the input to enable batching or cancel it by pressing
ESC.
:
it is displayed if at batching end the weight is different from the value set in formula by a
value higher than tolerance. Press ENTER
to cancel the alarm and continue with the
batching.
:
it is displayed if at batching start the fall value is higher than the product quantity to be
batched. Press ESC
to cancel the alarm and the batching.
: it is displayed if, at batching start, the formula recalled for running is not programmed.
Press the key ESC
to quit.
: it is displayed if, at batching start, the formula recalled for running exceeds the maximum
weight. Press the key ESC
to quit.
: it means that during batching the STOP key has been pressed, temporarily interrupting
the cycle; press the ENTER key to start it again, or STOP to terminate completely the
batching.
: it indicates that a power failure occurred during batching: press ESC to cancel the
batching or press ENTER
to resume batching again from the point of interruption.
:
during the batching it indicates that the product is not loaded. It is automatically cancelled
if the product increases. Press STOP
twice to cancel the batching.
: during the unload (Cycle End contact closed) it indicates that the product is not extracted.
It is automatically cancelled if the product decreases. Press STOP twice to cancel the
unload.
: it is displayed for 3 seconds if you try to stop the batching (by pressing twice STOP or
closing the related input) when the START input is closed. Open the START input to
cancel the alarm.
:
batching is cancelled. Press ESC to quit. If the alarm persists, contact technical
assistance.
: it is displayed when there is a weight alarm and it cancels the current batching. Press
ESC to go back to the weight display and check the alarm.
: the load cell is not connected or is incorrectly connected; the load cell signal exceeds
39 mV; the conversion electronics (AD converter) is malfunctioning; the load cell is a
4−wire and there are no jumpers between EX- and REF- and between EX+ and REF+.
: communication problems between transmitter and receiver; check electrical connections
and instruments configuration.
: the weight display exceeds 110% of the full scale.
: weight display on transmitting instrument exceeds 110% of full scale.
: internal instrument converter failure; check load cell connections, if necessary contact
technical assistance.
: the weight exceeds the maximum weight by 9 divisions.
Содержание W200-C
