LAUMAS W100, Инструкция по установке и эксплуатации

Страница: 30 / 40

- 26 -
RS232 CONNECTION
INSTRUMENT Connector Pin Signal
W100 TERMINAL
3 RS232: TXD
4 RS232: RXD
2 RS232: SHIELD, GND
COMMUNICATION SETTING
Into the
SERIAL COMMUNICATION SETTING section (see receiving instrument manual), select
the desired serial port and operation mode: WEIRIP (

) or WEIMOD (

).
It’s not possible to enable this function on both serial ports; in case of conflict, the last
serial set, remains active.
Settable parameters:
-

: transmission speed (2400, 4800, 9600, 19200, 38400, 115200; default: 9600).
-

: transmitting instrument address (only for

, from 1 to 99; default: 1).
-

: delay in milliseconds which elapses before the instrument replies (from 0 to 200 ms;
default: 0).
-
 :
-
 : no parity (default).
-
 : even parity.
-
 : odd parity.
-
 : stop bit (1 – 2; default: 1).
Receiving instrument parameters must be set with the same value of transmitting
instrument parameters.
Transmitting instrument
- SU
PPLY
RS232
- SU
PPLY
RS232
TX RX RX TX
Receiving instrument