Lauda L 100, Руководство по эксплуатации

Страница: 16 / 48

4 Commissioning
4.1 Set up and connect the hoses
WARNING!
Danger of device falling or overturning
Crushing, impacts
 Do not tilt the device.
 Position the device on an even, non-slip surface
with a sufficient load carrying capacity.
 Do not position the device close to table edges.
Take the following information into account:
 Hold on under the device to lift and carry it.
 Set device on a level surface.
 Be careful not to cover the ventilation openings, including the
ones under the device.
 Use a hose clip or cable tie to secure the hose nozzle and
hose against slippage!
 The pump connections on the device are self-closing. This
ensures that liquid does not flow out of the device.
 The included hose nozzles do not close.
1. Plug the hose nozzle into the pump connection.

Spring tension locks the locking plate in the up position.
A clicking noise indicates that the hose nozzle is securely
locked in the connection.
If the hose nozzle cannot be plugged into the pump connection,
then the locking plate on the pump connection is already locked.
Unlock the locking plate by pressing down as shown in the pump
connection illustration.
1. Unlock the locking plate by pressing down as shown in the
pump connection illustration.
2. Pull the nipple out of the pump connection.

Liquid will immediately flow out of the hose.
Connect the hose to the device
Fig. 8: Pump connection
Remove hose from the device
Commissioning
LOOP 16