Lauda H 2 P, Руководство по эксплуатации

Страница: 9 / 20

09/2020 Hydro Tissue Float Bath 9 / 20
6 Thermometer
Fix the thermometer holder to the bath rim, opposite the control panel, and place the glass thermometer into the holder.
The thermometer must not touch the bottom of the bath.
7 Filling Water into the Tissue Float Bath
Before initiation, fill either distilled or desalinated water up to approx. 1 - 2 cm beneath the rim of the
bath. The maximum filling quantity can be found in the technical data, chapter 11 of these instructions.
8 Installation, Temperature Regulation and Shutdown
Switch on the main switch. The green pilot lamp to the left above the main switch will light up. Set the required tempera-
ture on the turning knob of the temperature regulator. The temperature range of the bath is between approx. 5 K above
ambient to maximum approx. 80 °C. After setting the required temperature, the heating element is powered. The yellow
pilot lamp to the left above the temperature regulator lights up. The thermometer shows the current temperature. For safe
heating up to the maximum temperature cover the bath with a lid (accessory).
Caution, please observe by all means.
To turn off for longer shut-down periods switch the main switch to position O and disconnect the unit from the mains.
Empty the Evaporation Water Bath and dry the cabinet interior to prevent bacterial contamination.
Caution:
Hot surfaces at temperatures above 50 °C. Danger of burns. Take extreme care when
handling the unit because of the high operating temperatures.
9 Temperature Monitoring in Case of an Error
The Tissue Float Bath is protected against destruction by running dry or defective temperature controller by a temperature
cut-out (non readjustable, temperature-dependent cut-out). The cut-out cuts the power to the heating. A defective
temperature cut-out must be exchanged against an identical cut-out.