Slide the motor end and non-motor lid
sections onto the lid end support.
Measure and cut motor and non-motor
lid ends to fit. Attach the cut cover
pieces (M9363) to both sides of the mo-
tor and non-motor end lid.
The hinge attachment (X0940) should
be flush with the end of the lid and the
lid hinge is offset from the end.
Place assembled lid over the housing
and screw it into place using the 1 x
1
-
3/4 stainless steel screws (A2209).
10
11
12
13
16
14
15
Insert the lid hinge splices (M9362)
between each section of the lid end
support and the hinge and slide them
tightly together.
Remove the lid and hammer the plastic
anchors (A1706) into the holes.
Countersink the drill holes in the hinge.
With the lid completely assembled, set
it over the housing. Next, mark and drill
holes through the lid hinge approxi-
mately every 18 inches. Drill the holes
into the deck through the holes in the
lid hinge
Slide the center section through the
hinge into the position shown.
17
18
Installing The 309 Flat Lid
L992
6
Ver
2
.0, 10/22/18 BM
© Latham Pool Products, Inc. 201
8
. All rights reserved.
4 of 4
