Mark and cut the front side of the lid
end supports leaving at least 1in of flat
surface between the coping edge and
the lid end support.
Attach the 97 degree angled brackets
(A2430) to the back wall of the housing
1in below the top of deck.
Insert the end caps (A2426) to the lid
end supports.
Set the lid end support (A2429) in the
ends of the housing in order to get
an accurate measurement for the lid
panels.
1
2
3
4
7
5
8
6
9
Measure and cut the lid panels (X0048),
C-cap (X0053), and hinge attachment
(X0940) approximately 1 1/4in shorter
than the actual width to the inside of
the lid end supports. This allows space
for the cut cover and lid wedges to
attach to the ends of the lid panels to
cover any cuts.
Slide the lid panels (X0048) and C-cap
(X0053) together.
Measure and cut the lid hinge (X0939).
Measure from one lid end support to
the other.
Slide the hinge attachment (X0940) and
lid hinge onto the lid.
Use a rubber mallet to tap on the lid
wedges on both sides of the main lid
section.
Installing The 309 Flat Lid
© Latham Pool Products, Inc. 201
8
. All rights reserved.
3 of 4
