Laskomex Bastion Apus II, Руководство пользователя

Страница: 10 / 16

Installing and connecting the power adapter
The wire marked with a grey dotted line is plus, and the solid white one is minus – see
Fig. 3. The wires should be connected according to the connection diagram.
Installing and connecting the door release
The door release is controlled by the relay in the outdoor panel and must be powered
from a separate DC power adapter.
Install the door release in the gate or the entrance door according to the manufacturer's
recommendations. Then proceed to connect the wires in the outdoor panel (two black
wires), power adapter wires and the door release, as shown in the connection diagram
(see Figures 5, 6).
Fig. 7. Outdoor panel installation
6. Video doorphone operation
- Pressing the calling button ( ) on the outdoor panel triggers a calling signal in the
monitor and switches on the camera view (if an additional monitor has been installed,
the camera view will display on both monitors).
- To switch on voice communication, press the button (talk, see Fig. 1). In two-monitor
installations, if voice communication has been established by one of the monitors, the
other one will switch off after approx. 1 minute.
- If voice communication is not activated after calling, the monitor will automatically switch
off after approx. 1 minute.
- The talk time is limited to approx. 120 seconds, after which the phone will automatically
hang up.
- To hang up, press the button (talk) again.
wires should be connected to the outdoor panel with snap-on connectors (see Fig.
4b, p. 7). Place the panel against the hood and secure it with the mounting screw
(Fig. 8D, p. 10).
10
Pin to J100 socket
(power supply)
Fig. 8. Power socket connector of the monitor
View side
150cm
red
+
black
-
LASKOMEX PPUH, ul. D¹browskiego 249, 93-231 £ódŸ, tel. (42) 671 88 00, fax (42) 671 88 88, e-mail: laskomex@laskomex.com.pl, http://www.laskomex.com.pl