Manual: RS 800 G US, RS 800 RGY US, RS 1000 RGB US, RS 2300 RGB US RS-2700 RGB US
4 / 9
Revision Jun-13
Control panel
MODE:
select mode, or go up in menu
ENTER:
confirm changes, or go down in
menu
UP/ DOWN:
change DMX address
Operating modes:
Automatic mode: built-in patterns are displayed
Music active: laser is controlled from built-in microphone
“DMXAddr“: DMX512 mode-. Here you can change the DMX
address:
“Open“: change address
“Up“ & “down“: increase/decrease address
“Save“: save new address
“LCD display memory function“:
save settings automatically.
ILDA mode
When an ILDA compatible interface is connected to the laser, the
laser is automatically switched to ILDA mode. Output is then controlled from a PC running software.
The laser uses pins 4 and 17 of the ILDA signal to detect the presence of an ILDA interface.
Further information can be found in the software manual.
Please note:
the scanners are set to a scanspeed of ca. 22000 PPS at ca. 30° scanangle. If you
increase the scanspeed, first reduce the scanangle (image size). Otherwise you may damage the
scanners! When using with different scanspeed/scanangle readjustment of the scanner drivers may be
necessary, if in doubt, contact your dealer.
DMX mode
Channel
DMX512 value
Function
1
blue
0~63
Auto-Music Mode (Ch 1&2 valid)
64~127
Auto-mode (Ch 1&2 valid)
128~191
Music-edit mode (All channels valid)
192~255
Manual mode (All channels valid)
2
Colour
0~63
No Beam
64~127
Single colour laser: Strobe
Multicolour: colours
128~192
Single colour: Fluxion blanking
Multicolor: Colour change
193~255
On
3
Pattern group
0~42
Pattern group 1
43~85
Pattern group 2
86~128
Pattern group 3
129~171
Pattern group 4
172~214
Pattern group 5
215~255
Group 6 cartoons
4
Pattern
0~255
32 patterns
5
Speed
0~255
slow to fast
6
0~63
No function
64~127
Rotate horizontally
128~191
Rotate vertically
1
Operation LED
2
Working LED: controlboard working
3
DMX LED: DMX connected
4
ILDA LED ILDA connected
5
DMX In/Out
6
Remotelock: connect emergency switch.
If no emergency switch is connected
use the 9 pin plug supplied.
7
Security switch: Laser on/off
8
ILDA connector in/out
9
Power switch: power on/off
10
Power: connect to mains
