USER MANUAL: Laserworld Scanner Set LW-80k
Date: 07/2010
page
4
of
6
Connecting to ILDA output: connect the signals marked (ILDA) to the following pins
of a 25 pin male Sub D connector:
of X driver to pin 1, Y driver to pin 2
Signal- of X driver to pin 14, Y driver to pin 15
Signal gnd (both drivers) to pin 25
Power supply:
Connect the outputs to the corresponding signals on both driver boards.
Connect L, N and protective ground to mains.
Mounting the galvos
the picture to the right shows how the galvos
are mounted into the galvo mount. (Laserbeam
entering from the right of the picture, X galvo
mounted from the top, Y galvo from left).
Tighten the screws in the galvo mount, so the
galvos can not move.
