Manual: DS-1000RGB, DS-1000RGB FB4
page 10 / 34
Please note that not each pattern can be combined with each effect.
•
ILDA control
Connect your device („ILDA IN“) via an ILDA cable to an interface / controller. ILDA mode
starts immediately. Use a laser control software, e.g. Laserworld Showeditor, to run the
device. Use „ILDA OUT“ to connect it to another device.
•
Sound mode (10)
The device reacts to ambient noise:
•
Master-Slave-Mode (3, 10)
To use the daisy chain / Master-Slave-Mode connect two (or more) laser projectors of the
same series via DMX cables:
Master projector (DMX out) -> DMX cable -> slave projector 1 (DMX in) ;
slave projector 1 (DMX out) -> DMX cable -> slave projector 2 ...etc.
To use this mode, DIP switches ‘3‘ and
‘10‘ have to be switched on.
DMX cable
Slave projector
Master projector
Select auto or music mode
at the master projector
(see above)
8. Turn device off
To turn off the device switch it off („OFF“), turn the key ‚OFF‘ and disconnect the power
cable from the mains.
Important Note:
Operate scanners/galvos only at appropriate speed according to the res-
pective scan angle. Too high scan speed will damage the scanning system.
