Page 53
Printer Driver Setup For Rotary Attachment
To set up the printer driver for use with the rotary
attachment you would simply follow the same setup
procedure that you use when working with the flat
grid bed.
The difference will be that when you get to the
“Paper”
section of the setup simply follow the
instructions on the right instead.
Step 1.
Tick the rotary
attachment box
Step 2.
Input the measurements you acquired during step 7 on page 51.
X (being the length of your object) and the diameter.
Step 3.
Insert the offset
acquired at step
12 on page 52
The smallest diameter that can be fitted to the rubber cone pad is 56mm.
The largest diameter that can be fitted to the rubber cone pad is 94mm.
The maximum diameter of object that can be engraved is 180mm.
The maximum length of object that can be engraved is 450mm.
56
- 94
mm
180
mm
450 mm
(*1)
(*2)
(*3)
(*1)
(*2)
(*3)
}
The unit rotates in a clockwise direction
when viewed from the right hand end
of the laser (the control panel end)
as shown in the picture below.
Useful Rotary Attachment Information
Printer Driver Setup for Rotary Attachment Information
