LaserLiner ThermoSpot-Vision, Руководство пользователя

Страница: 15 / 224

ThermoSpot-Vision
15 GB
Settings for measuring modes 8
Emissivity
(see Point 17)
Set emissivity coef Ƃ cient
Select the material type with / . Concrete, glass,
human skin, ice/water, plastic, Wood. For an individual
emissivity coefficient select "E" and confirm with Enter.
Set the value with
/ .
To save and exit menu press the "ESC" button.
Alarm High
Alarm temperature, alert - temperature above
threshold
Set temperature or disable function with / .
To save and exit menu press the "ESC" button.
Alarm Low
Alarm temperature, alert - temperature below
threshold
Set temperature or disable function with / .
To save and exit menu press the "ESC" button.
Laser
Dual laser
Enable/disable laser with / .
To save and exit menu press the "ESC" button.
Auto mode
Automatic trigger (dual laser)
Enable or disable with / . IR measurement takes place
continuously when enabled. A lock symbol appears next to
the battery indicator.
To save and exit menu press the "ESC" button.
Max/Min
Min/Max display
Enable or disable display with / .
To save and exit menu press the "ESC" button.
Average/Dif
Average value/difference display
Enable or disable display with / .
To save and exit menu press the "ESC" button.
Ambient
TEMP/%RH
Ambient temperature/relative humidity display
Enable or disable display with / .
To save and exit menu press the "ESC" button.
Dewpoint/wet-
bulb
Dew point/wet-bulb temperature display
Enable or disable display with / .
To save and exit menu press the "ESC" button.
Type-K
(see Point 14)
Type-K display (only with Type-K sensor connected)
Enable or disable display with / .
To save and exit menu press the "ESC" button.
In addition to the general system settings, other settings are possible speci Ö -
cally for measuring mode. These settings are effective for following modes:
IR CAM, IR MEASURE, DEWPOINT, DATALOG. Therefore, check the speci
Ö c
setting before each measuring task.
ON/OFF: ON/OFF
Use the navigation buttons to select a corresponding mode from the start menu
and press "ENTER" to con
Ö rm. Press the "ENTER" button again to access the
settings of the measuring mode:
Enable/disabled Enable/Disable: