Laser STB-7000, Руководство пользователя

Страница: 21 / 22

18
TROUBLE SHOOTING
Problem Possible Cause Solution
No Picture Power is not connected
Connect the power and
make sure unit is turned on.
Screen Shows “No Signal”
Antenna cable is not
connected Check the antenna
connection to the rear of the STB
No sound
No or incorrect audio cable
connections
Check connections of audio cables
Sound is muted Un-Mute audio
No picture but sound OK
No or incorrect Video cable
connections Make sure cables are connected
correctly.
Remote Control is not
responding
Batteries are flat Replace.
Picture is breaking up Signal is too weak Check antenna connection.
USB device is not detected Not powered correctly
Check power source (if fitted) or
reconnect.
Movie Payback out of sync
Faulty file
Check file to ensure not encoding
issue
File is too large for STB
Re-encode file at lower resolution
and/or data rate
SPECIFICATIONS
TUNER
INPUT FREQUENCY
170~230MHz
471~860MHZ
RF INPUT LEVEL -25~-82dBm
IF BANDWITCH 7MHz & 8MHz
MODULATION QPSK, 16QAMM, 64QAM
VIDEO
DECODER FORMAT
MPEG4 AVC/H.264 HP@L4
MPEG2 MP@ML.HL
OUTPUT FORMAT 576p, 720p, 1080i, 4:3 & 16:9
OUTPUT PORT HDMI (V1.4) YpBpR, cvbs
AUDIO
DECODER FORMAT MPEG-1 (layer 1&2&3) WMA, AC3
AUDIO OUTPUT 2 X RCA (L/R), COAXIAL SPDIF
USB 2.0
SUPPORTTED CAPACITY 750GB
SUPPORTED MEDIA AVI, DIVX
POWER
SUPPLY VOLTAGE 100~240VAC 50/60Hz
MAXIMUM POWER CONSUMPTION 8W
STANDBY POWER CONSUMPTION < 1W
Contact information
For more information on this product and technical support please visit
HTTP://WWW.LASERCO.COM.AU