LARTET DC-24S, Руководство пользователя

Страница: 40 / 41

4-20 COMMUNICATION PROTOCOLS CHAPTER 4
DC-24 and DC-25 operation manual
4.4. Set up IP Address using the DeviceInstaller.
Before being able to communicate with the display an IP address must be assigned. To assign
an IP address the DeviceInstaller program from Lantronix must be used, which can be
downloaded free from their website: www.lantronix.com
Select: Support
→ Technical Support → Firmware/Downloads.
Select: DeviceInstaller.
Once the program is installed and running, press the “Search” button to locate the connected
displays. The display must be turned on and connected to the network.
If there are no network problems, a screen similar to this should be displayed.
The IP address with which the equipment is supplied is: 10.30.90.10
The Hardware Address is the unit MAC code.
To assign the IP address you must first select the equipment by clicking on the XPort-03 to
which you wish to assign the address. Then press Assign IP and follow the instructions.
IMPORTANT: All units are dispatched from the factory with the same IP address.
Therefore to configure various units, they must be connected to the Ethernet and the
address must be assigned one by one.
4.5. Modifying the port settings.
To modify the port configuration the DeviceInstaller program from Lantronix must be used,
which can be downloaded free from their website: www.lantronix.com
Select: Support
→ Technical Support → Firmware/Downloads.
Select: DeviceInstaller.
Once the program is installed and running, press the “Search” button to locate the connected
displays. The display must be turned on and connected to the network.
If there are no network problems, the same screen for configuring an IP address should be
displayed. See 4.1
“IP Address.”
To access the setup you must first select the unit clicking on the XPort-03 that you wish to
modify.
.