ED.
01 - 09/2022 - Cod. 150206
www.larius.com
49
OMEGA 5:1
34
31
32
33
35
37
36
39
38
Fig. 5N
Fig. 6N
IT
EN
Warning:
tighten here
• Turn counterclockwise the rod guiding screw (
31
) [take
care to the washer (
32
)] and check the seal inside the
screw (
31
) is undamaged.
• Take out the screws (
33
) [take care of the washers (
34
)]
and remove carefully the cylinder (
35
) (do not bend it during
extraction in order to avoid that motor piston may damage
the internal surface of the cylinder).
• Extract the motor piston from the motor support (
36
).
• Verify the O-ring (
37
) is undamaged.
• Tighten the lower edge of the piston rod using pliers (see
illustration) and unscrew the fitting (
38
) with a wrench.
• Remove the motor rod (
39
) and check it is undamaged.
• Rub the motor rod (
39
) with vaseline grease before inserting
it into the housing of the piston rod.
• Tighten again with pliers the lower edge of the piston rod
and screw the fitting (
38
) (application of a sealant on the
thread is advisable).
