ED.
01 - 09/2022 - Cod. 150206
www.larius.com
44
OMEGA 5:1
J
I
2
1
Fig. 1I
Fig.2I
Fig. 2H
IT
EN
SETTING-UP
ANTIFREEZE SYSTEM
CONNECTION TO THE FEED AIR
For pump feed use a hose with an internal diameter no lower
than 20 mm.
CONNECTION OF THE MATERIAL OUTLET HOSE
Connect the high pressure hose at the outlet of the pump.
It is recommended to tighten the fittings.
Install at the pump inlet an air pressure regulator
(it is suggested complete with condensate filter
and lubricator). The outlet pressure of the material
is 5 time the inlet pressure of the pump feed air.
Therefore, it is extremely important to adjust the
value of the feed air pressure.
PUMP FASTENING ON THE HOIST
For the correct fastening of the pump on the ram, follow the
procedure described in the manual for use and maintenance of
the double post ram.
The machine is equipped with an anti-freeze
system that allows it to work even at very low
temperatures. However, after a few minutes of
operation, the upper metal outer surface cools
dramatically. Avoid touching the area indicated.
Contact of the skin with the low-temperature area
may cause frostbite. Common working clothes
and leather gloves provide adequate protection.
In harsh climatic conditions it is necessary to insert some liquid
antifreeze (
1
) within the FRL group (
2
).
If 100% pure antifreeze liquid is used, it is recommended the
dilution shown in the table.
DILUITION RECOMMENDED FOR PURE PRODUCT
% water diluition
°C, environmental temperature
10%
-5
20%
-10
30%
-20
40%
-25
50%
-37
60%
-50
NOTA
When the pump is used in places with higher
temperatures, the phenomenon indicated
above may not occur and therefore it is not
necessary to use antifreeze.
