LAPITEC INDULAP001, Руководство пользователя

Страница: 14 / 65

Problem Cause/Notes Solution
The drawer fitted underneath the
induction hob gets very hot
When you use the hob, certain areas
of the drawer below may reach
temperatures of up to 60°C.
This is not a malfunction.
1. Check that the induction hob has been
installed in compliance with the installation
instructions.
2. Do not keep flammable items in the drawer.
My hob won’t turn on Possible problem with the electricity
supply.
1. Check that the device is correctly connected
to the electricity supply. Make sure that it has
been installed correctly by calling an authorised
installation technician or a qualified electrician
in order to resolve the issue.
2. Make sure that the malfunction isn’t being
caused by the fuse. Reset the circuit breaker/
RCD (residual current device) or replace the
fuse.
3. Contact an authorised assistance centre.
If the above suggestions do not resolve the issue,
we recommend that you request a visit from an
assistance technician.
The hob trips the residual current
device of my home’s electrical
system.
Possible problem with the electricity
supply or there may be a fault with the
appliance
1. Ensure that the residual current device is
sufficient for the power to be absorbed. Check
with a qualified electrician whether you are
using the right residual current device and
whether the hob is connected to a separate
group of fuses.
2. Make sure the device is properly connected
to the electricity supply. Check that it has been
installed properly by contacting an authorised
installation technician.
3. Contact an authorised assistance centre.
If the above suggestions do not resolve the issue,
we recommend that you book an appointment
with a qualified technician.
WARNING: We advise you not to use the
appliance until the problem has been completely
resolved. Unplug the appliance and do not
reconnect it until you are sure that it is safe to
do so.
Troubleshooting list
27
User Manual English
INDULAP001
Errors
Code Table
Phenomena
No cooker
Overvoltage
NTC1
is of open circuit
NTC2
is of open circuit
Low voltage
IGBT
Over-temperature
NTC1
is of short circuit
NTC2
is of short circuit
High temperature
attention
No safety mat
Operation Voltage:
Left Rear Burner Power
Left Bridge Zone Power
Right Front Burner Power
Left Front Burner Power
Right Rear Burner Power
Right Bridge Zone Power
Max. Power
AC 220V - 240V, 50Hz/60Hz
max. 1600W
max. 2800W
max. 1600W
max. 2000W
max. 2000W
max. 2800W
7000W
Code
E1
Change to the shutdown after about 60s
Change to the shutdown after sounding
twice
Safety mat should be put in correct
position for cooktop operation
Until the voltage is restored
Until the fault is eliminated
Give out two long and three
short beep prompts every 5
seconds
Give out four long and five
short beep prompts every 5
seconds
Give out three long and four
short beep prompts every 5
seconds
Give out two long and four
short beep prompts every 5
seconds
Give out four long and four
short beep prompts every 5
seconds
Give out four long and three
short beep prompts every 5
seconds
Give out three long and five
short beep prompts every 5
seconds
E3
E7
E9
H
E2
E0
E8
Ee
C
Sound Remarks
26
User Manual English
INDULAP001