6: Line and Tunnel Settings
XPort Pro User Guide
53
For commands that can take address information (ATD, ATDT, ATDP), the destination address
can be specified by entering the IP Address, or entering the IP Address and port number. For
example, <ipaddress>:<port>. The port number cannot be entered on its own.
For ATDT and ATDP commands less than 255 characters, the XPort Pro replaces the last
segment of the IP address with the configured Connect Mode remote station address. It is possible
to use the last two segments also, if they are under 255 characters. For example, if the address is
100.255.15.5, entering “ATDT 16.6” results in 100.255.16.6.
When using ATDT and ATDP, enter 0.0.0.0 to switch to the Command Line Interface (CLI). Once
the CLI is exited by using the CLI exit command, the XPort Pro reverts to modem emulation mode.
By default, the +++ characters are not passed through the connection. Turn on this capability
using the modem echo pluses command.
To configure modem emulation:
1. Select
Tunnel > Modem Emulation
at the top of the page. The
Tunnel 1 Modem Emulation page appears.
Figure 6-20 Tunnel 1 Modem Emulation
2. Enter or modify the following settings:
A/
Repeat last valid command.
Table 6-19
Modem Emulation Commands and Descriptions (continued)
Command (continued)
Description
