Lantronix xPico 200 Series, Инструкции по прошивке сертификации

Страница: 5 / 21

xPico ® 200 Certification Firmware Instructions 5
Overview
This document provides instructions on leveraging Lantronix ® xPico ® certificates. In many
cases, the Lantronix modular transmitter certification can be leveraged without acquiring full re-
certification effort in products that use the Lantronix module.
The xPico 200 series has modular approval for FCC, IC, EU, Japan, China and Australia/New
Zealand. All xPico certificates can be found in the xPico 200 module documentation at
https://www.lantronix.com/products/xpico-200/#tab-docs-downloads .
It is recommended that you consult with your certification laboratory to develop your
certification plan for your product that includes the xPico 200 series module. The xPico 200
series module certification tests were completed at Bureau Veritas in Hsinchu, Taiwan.
Requirements for Leveraging Lantronix xPico 200 Certificates
The following conditions are required to leverage Lantronix modular transmitter certifications:

Following the antenna and layout instructions in the xPico 200 Series Integration Guide .

Using antennas of similar type and equal or less gain than the antennas listed in the
xPico 200 Series Integration Guide .

Positioning the xPico 200 module at least 20 cm from a human body and the
transmitting antennas at least 20 cm from all other transmitters. Lantronix has not
completed SAR testing on the xPico 200 module.

Running EMC tests including the FCC 15-part B and EN 301 489 -1/-17. When
leveraging the modular certification, the transmitter and receiver-specific tests normally
do not need to be performed.

Placing certifications for the xPico 200 transmitter IDs for various regions on the end-
product label according to conditions listed in the
Compliance section of the xPico 200
Series Data Sheet. See https://www.lantronix.com/products/xpico-200/#tab-docs-
downloads .

Running two certification testing modes. See Certification Test Modes .
Disqualifications to Leveraging Lantronix xPico 200 Certificates
The following conditions disqualify the leveraging of Lantronix xPico 200 certifications:

Using a different type of antenna than that shown in the xPico 200 Series Integration
Guide .

Using an antenna with higher gain than the antennas called out in the xPico 200 Series
Integration Guide .

Installing the xPico 200 module antenna in a location where it is expected to be less
than 20 cm from a human body. Under this scenario, SAR testing would need to be
completed.

Installing the xPico 200 module antenna within 20 cm of another transmitter module.

Installing the xPico 200 module in a country or region not referenced in the Compliance
section of the xPico 200 Series Data Sheet. See
https://www.lantronix.com/products/xpico-200/#tab-docs-downloads .